TM 5-3825-226-24 DIFFERENTIAL AND CARRIER ASSEMBLY REMOVE DIFFERENTIAL AND CARRIER ASSEMBLY Tools Needed A B 8S7620 Base Assembly 2 8S7650 Cylinder 2 8S7645 Hose Group 1 5P3100 Pump Group 1 8S7640 Stand 2 8S7611 Tube 2 8S7615 Pin 2 8S8048 Saddle 2 start by: a) remove crankcase guard* b) remove lower drive shaft 1. Put blocks under the scraper wheels for safety. 2. Drain the oil from the differential and both final drive   compartments.      The   total   capacity   is   8 U.S.  gal.  (30.3 liter). 3. Remove  the  final  drive  covers  and  move  each axle out approximately 12 in.  (30 cm). 4. Remove   the   bolts   from   clamps   (3)   and   (5). Remove muffler (4) and tube (1). 5. Remove  eight  nuts  (2)  from  the  bolts  that  hold the axle housing to the frame. 6. Use  .75  in.    (19.1  mm)  diameter  steel  rod  and make four 15 in.  (38.1 cm) long guide pins.  Put 3/4"-16 NF threads on one end of the guide pins and install a nut to make guide bolts. 7. Make  a  replacement  of  four  of  the  bolts  that hold   the   axle   housing   to   the   frame   with   the fabricated guide bolts (6) as shown. 8. Remove  bolt  (7)  from  the  assembly.    Remove the   bolt   from   the   clip   that   holds   right   wheel brake   line   (8)   to   the   frame   above   the   axle housing. 9. Use tooling (A) to lift the machine approximately 4 in.  (10.2 cm). 10. Install  tooling  (B)  under  the  frame  as  shown. *This operation is in the ENGINE DISASSEMBLY AND ASSEMBLY. 3-228