CONTROL PANEL SWITCHES AND RELAYS (cont)

CONTROL PANEL SWITCHES AND RELAYS (cont) - TM-5-3825-229-14P_115

CONTROL PANEL SWITCHES AND RELAYS (cont) - TM-5-3825-229-14P_117

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
98

TM 5-3825-229-14&P 4-12. CONTROL PANEL SWITCHES AND RELAYS (cont) d. Testing Start Switch and Engine RPM Switch (cont). (5) Toggle switch to bottom position. Multimeter display should go to zero ohms, indicating continuity. Toggle switch back to center position. (6) Connect black test lead to right center terminal of switch. Connect red test lead to right top terminal. (7) Toggle switch to upper position. Multimeter display should go to zero ohms, indicating continuity. Toggle switch back to center position. Meter display should return to infinity (°°), indicating no continuity. (8) Connect red test lead to right bottom terminal of switch. (9) Toggle switch to bottom position. Multimeter display should go to zero ohms, indicating continuity. Toggle switch back to center position. (10) If test results are not the same as described above, the switch must be replaced. e. Removal. (1) Unscrew two screws (1) on right side of panel (2). Open panel (2). (2) Tag and remove all wires (3) from switch (4). (3) Remove nut (5) and washer (6) holding switch (4) to control box panel (2). (4) Remove switch (4). f. Installation. (1) Install switch (4) through hole in control box panel (2). Secure with nut (5) and washer (6). (2) Connect wires (3) to proper switch terminals. (3) Close panel (2) and install two screws (1). g. Engine Relay Panel (1) Removal. (a) Disconnect harness wires (1) and engine wires from relays (9 and 13) and glow plug resistor (17). 4-24

Privacy Statement
Press Release
Contact