TM 5-3825-229-14&P
4-16. CLEARANCE/TURN AND STOP/TAIL LIGHTS (cont)
b. Disassembly.
(1)
To remove lens (6), insert screwdriver blade fully under lens flange. Pry carefully at several
points if necessary. When removing lens, place one hand over lens face at pry point, to
prevent flying shards if lens breaks.
(2)
Remove pre-formed packing (7) from groove (8).
(3)
Remove lamp (9) from socket (10).
c. Assembly.
(1)
Install lamp (9) in socket (10).
(2)
Install pre-formed packing (7) in groove
(8).
(3)
Install lens (6).
(4)
Install gasket (11) on light.
d. Installation.
(1)
Connect wires (4), using conductor splices.
(2)
Install light assembly (3) in hole in frame (2).
(3)
Secure with four screws (1).
(4)
Connect electrical power and test for proper operation.
4-17. CLEARANCE/MARKER LIGHTS
THIS TASK COVERS:
a.
Removal
c.
Assembly
b.
Disassembly
d.
Installation
INITIAL SETUP:
Equipment/Materials Required:
Tools Required:
Conductor Splice (NSN 5940-01-079-1375)
(Item 21, Appendix E)
Nomenclature:
Equipment Conditions:
General Mechanics
Tool Kit
Ref
Conditions
2-23 Intervehicular cable disconnected.
4-35
