TM 5-3825-229-14&P
4-14. CONTROL PANEL CABLES (cont)
a. Testing (cont
(c)
Meter should indicate zero ohms (continuity) if wire is good.
(d)
Test each wire in connector cable for continuity. If meter indicates infinite ohms (broken
wire) for any wire, replace cable.
(5)
Test for continuity of each wire in remaining cable that connects rear control box to engine
and water distribution system.
(a)
Place one test probe on any cable wire connected to a terminal in rear control box. Note
color of wire.
(b)
Place remaining test probe on cable wire of same color at other end of cable.
(c)
Meter should indicate zero ohms (continuity) if wire is good.
(d)
Test each wire in connector cable for continuity. If meter indicates infinite ohms (broken
wire) for any wire, replace cable.
b. Removal.
(1)
Refer to para. 4-10 and disconnect and remove cables from control box.
(2)
Disconnect and remove cable from control box as follows:
(a)
Remove screws and remove control box cover from control box.
(b)
Refer to wiring diagram and disconnect harness wires from tachometer or ammeter,
switches and indicator lights.
(c)
Remove lock nut from cable grip inside control box and remove cable grip, harness wires
and harness from control box.
c. Installation.
(1)
Install harness wires and cable grip through hole in control box.
(2)
Install lock nut over wires. Secure cable grip to control box with lock nut.
(3)
Refer to wiring diagram and connect harness wires to tachometer or ammeter, switches and
indicator lights.
(4)
Install control panel on control box. Secure with two screws.
(5)
Refer to paragraph 4-10 and connect and install cables on remote control box.
(6)
Refer to para. 4-22 and connect cables to battery.
4-32
