TM 5-3825-229-14&P
4-15. FUSE (cont)
b. Testing. Visually check fuse. If fuse element is open, fuse is bad and must be replaced.
c. Installation.
(1)
Place fuse (4) in fuse holder (3) and twist lock fuse holder together.
(2)
Install instrument panel (2) on rear control box. Secure with two screws (1).
(3)
Refer to para. 4-22 and connect cables to battery.
4-16. CLEARANCE/TURN AND STOP/TAIL LIGHTS
THIS TASK COVERS:
a.
Removal
c.
Assembly
b.
Disassembly
d.
Installation
INITIAL SETUP:
Tools Required:
Equipment/Materials Required:
Nomenclature:
Conductor Splice (NSN 5940-01-079-1375)
(Item 21, Appendix E)
General Mechanics
Tool Kit
Equipment Conditions:
Ref
Conditions
2-23 Intervehicular cables disconnected.
a. Removal.
CAUTION
Lenses can break during removal.
(1)
Remove four screws (1) holding tail lights
to frame (2).
(2)
Gently pull tail light assembly (3) and
wires (4) out of hole in frame (2).
(3)
Cut wires (4) on both sides of crimped
wire connector (5).
(4)
Remove tail light assembly (3). Remove
gasket (11).
4-34
