SERVICE ENGINE (cont) - TM-5-3825-229-14P

Section XI. MAINTENANCE OF ENGINE ASSEMBLY

SERVICE ENGINE (cont) - TM-5-3825-229-14P_183

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
164

TM 5-3825-229-14&P 4-46. SERVICE ENGINE (cont) a. Change oil. (1) Place drain pan under drain plug. (2) Remove drain plug (1). Discard or recycle drained oil. (3) Install drain plug (1) and tighten securely. Do not overtighten. (4) Remove oil filter element (2) and install new element. (5) Fill crankcase with correct type of oil (see para 3- 2). CAUTION Do not start pump engine unless distributor pump is primed. Refer to para. 4-16 to prime pump. (6) Run engine. Check for oil leaks around filter element and drain plug. (7) Stop engine so that oil can drain down. Check oil level: oil level should be at FULL mark. Changing Engine Oil b. Check Oil Level. (1) Remove dipstick (3) from dipstick tube (4) and wipe oil from dipstick. (2) Insert dipstick and remove again. (3) Oil on dipstick should read between ADD and FULL marks. If oil is at or below ADD mark, add oil until dipstick reads FULL. (4) Insert dipstick back into engine. c. Drain antifreeze. (1) Make sure engine is level to ensure complete draining. Checking Oil Level WARNING Pressurized coolants have higher boiling point than water. NEVER open radiator filler cap when coolant temperature is above 212°F (100C) or while engine is running. 4-90

Privacy Statement
Press Release
Contact