THERMOSTAT AND COOLING LINES (cont) - TM-5-3825-229-14P

THERMOSTAT AND COOLING LINES (cont) - TM-5-3825-229-14P_188

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
169

TM 5-3825-229-14&P 4-46A. THERMOSTAT AND COOLING LINES (cont) b. Testing Thermostat (cont). (2) Heat water and stir gradually. Check water temperature with a reliable thermostat. (3) Observe thermostat as water temperature rises. Thermostat should begin to open when temperature is within 3C (5F) of the nominal temperature (82C, 180°F). Thermostat should be fully open at 12C (22F) above the nominal temperature. (4) Thermostat is not adjustable and must be replaced if it does not operate within the above limits. Testing Thermostat c. Installation of Thermostat. (1) Clean all old gasket material from cover (2) and mounting surface on water pump (3). (2) Install thermostat (7) in water pump (3) so that bypass plate is positioned above bypass opening. (3) Install new cover gasket (6) on water pump. Install cover (2), with attached hose (5), on water pump. (4) Secure cover with two screws (1) and washers (4). Tighten screws to a torque of 17 lb-ft (23 Nm) (wet). (5) Fill cooling system. Refer to para. 4-46. g. d. Cooling Lines. (1) Removal. (a) Loosen clamps (1) and (4). Remove hose (2) from top of radiator (3) and from top of water pump (5). (b) Loosen clamps (6) and (8). Remove hose (7) from bottom of radiator (3) and from bottom of water pump (5). (2) Installation. (a) Install hose (7) to bottom of water pump (5) and secure with clamp (8). (b) Install hose (7) to bottom of radiator (3) and secure with clamp (6). Removing and installing Cooling Lines 4-95

Privacy Statement
Press Release
Contact