TM 5-3825-229-14&P
4-46B. ENGINE SAFETY CONTROLS (cont)
b.
Oil Pressure Switch (cont).
(2)
Installation.
(a)
Remove tape and install oil pressure switch (3) in crankcase (4).
(b)
Connect wires (1) to terminals (2) on pressure switch (3).
(c)
Fill engine crankcase (para. 4-46. a.).
(d)
Connect battery cables (para. 4-22).
4-46C. ENGINE STARTING DEVICES
THIS TASK COVERS:
a.
Glow Plugs
b.
Crankcase Heater
INITIAL SETUP:
Tools Required:
Equipment/Materials Required
Nomenclature:
Sealant (Item 11, Appendix E)
General Mechanics
Equipment Conditions:
Tool Kit
Ref
Conditions
4-22
Battery cables disconnected
4-56
Engine door removed
a.
Glow Pluqs.
(1)
Removal.
(a)
Remove nut (1) and washer (2) on glow plug (4)
at No. 4 cylinder rear of engine.
(b)
Disconnect harness wire and wire (3) from glow
plug. Remove nuts (1) and washers (2) and
disconnect three wires (3) from between
remaining glow plugs.
(c)
Use a wrench and remove four glow plugs (4)
from engine.
Glow Plugs
4-98
