ENGINE STARTING DEVICES (cont)

ENGINE SAFETY CONTROLS (cont) - TM-5-3825-229-14P_190

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
173

TM 5-3825-229-14&P 4-46C. ENGINE STARTING DEVICES (cont) a. Glow Pluqs (cont). (2) Installation. (a) Install four glow plugs (4) in ports in engine. Tighten glow plugs to a torque of 14 lb-ft (19 Nm) (wet). (b) Connect three wires (3) to tops of glow plugs (4). On glow plug at No. 4 cylinder (rear of engine) connect harness wire to tops of plug. (c) Install four washers (2) and nuts (1) to secure wires to top of plugs. b. Crankcase Heater. (1) Removal. (a) Drain engine cooling system and engine block. Refer to para. 4-46. (b) Refer to para. 4-54 and remove throttle control actuator from the engine. (c) Disconnect wire (1) if it is connected to crankcase heater (2). (d) Use a sharp bladed instrument such as a screwdriver and pry crankcase heater (2) from engine crankcase. Discard heater. Crankcase Heater (2) Installation. (a) Clean surface of port in side of engine crankcase and wipe dry. (b) Apply a light bead of sealant to outside diameter of new crankcase heater (2) and to the inside diameter of the plug installation port. (c) Carefully seat new crankcase heater (2) in port in bore. Use a rubber or leather hammer to tap around circumference of heater. Continue driving heater into bore until it is fully seated. (d) Refer to para. 4-54 and install throttle control actuator on engine. (e) Refer to para. 4-46 and fill engine cooling system. (f) Refer to para. 4-22 and connect cables to battery. 4-99

Privacy Statement
Press Release
Contact