SERVICE ENGINE (cont) - TM-5-3825-229-14P

SERVICE ENGINE (cont) - TM-5-3825-229-14P_184

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
167

TM 5-3825-229-14&P 4-46. SERVICE ENGINE (cont) g. Fill Cooling System (cont). (3) Fill system with clean antifreeze and water solution (50/50) until level is about one inch below filler neck. (4) When coolant appears at water pump plug (2), torque plug to 150 lb-in (17 Nm) (wet) and finish filling. NOTE In extremely low temperatures, -31C (-25F) or lower, increase percentage of antifreeze. CAUTION Do not start pump engine unless distributor pump is primed. Refer to para. 2-16 to prime pump. (5) Run engine for 10 minutes or until thermostat opens. As coolant circulates, air trapped in cylinder head will be released. Filling Cooling System WARNING Contact with hot coolant can cause serious burns. Allow cooling system to cool before releasing pressure. (6) Fill with additional coolant as needed. Maintain level so it is visible at the bottom of the filler neck. (7) Shut down unit and install filler cap. h. Check Wiring. (1) Check engine electrical wiring for breaks, damaged insulation and loose connections. Refer to para. 4-21 for repair of electrical wiring. 4-93

Privacy Statement
Press Release
Contact