ALTERNATOR (cont) - TM-5-3825-229-14P

FAN AND FAN BELT (cont). - TM-5-3825-229-14P_217

ALTERNATOR (cont) - TM-5-3825-229-14P_219

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
200

TM 5-3825-229-14&P 4-58. ALTERNATOR (cont) a. Testinq. (1) Prepare multimeter to measure DC voltage per instructions supplied with multimeter. (2) Connect negative lead of multimeter to a good ground on the alternator. (3) Connect positive lead of multimeter to positive terminal of alternator. CAUTION Do not start the pump engine unless distributor pump is primed. Refer to para. 2-16 to prime pump. (4) Start pump engine (para. 2-12). Run engine at fast idle of approximately 1000 RPM. (5) Voltage reading should be 13.8 to 14.8 volts. If voltage is not within limits, replace alternator. (6) Refer to para. 2-14 and stop engine. b. Removal. WARNING Electrical shock hazard exits. Disconnect battery cables (para. 4-22). (1) Disconnect harness wires (1) from alternator (2). (2) Refer to para. 4-57 and remove fan belt from alternator pulley. (3) Remove five screws (5) and flat washers (6) and remove belt guard (7). (4) Remove two screws (3) and flat washers (4) and remove adjusting strap (9) and guard (8). Remove spacer (10). (5) Support alternator (2) and remove nut (1 1), flat washer (12) and screw (13). Remove spacer (14) and remove alternator (2). (6) Use a suitable puller and remove pulley (15) and adapter (16) from alternator shaft. (7) Remove two screws (17) and flat washers (18) and remove bracket (19) from engine. 4-126

Privacy Statement
Press Release
Contact