TM 5-3825-229-14&P
5-6. ENGINE ASSEMBLY (cont)
a
Removal (cont).
(2)
Disconnect brace supporting water piping from engine flywheel housing (para. 4-60).
(3)
Remove water distributor pump (para. 5-19).
(4)
Attach a suitable lifting device or chain to lifting eye at front of engine and to rear
engine mounting bracket.
(5)
Remove four nuts (2), lockwashers (3), screws (4) and flat washers (5).
(6)
Carefully lift engine assembly (1) to clear plates (8 and 9). Remove four spacers (6),
eight resilient mounts (7), and plates (8 and 9) from beneath engine.
(7)
Carefully lift engine from rear of semitrailer. Guide engine to prevent engine from
swinging Swing engine assembly away from semitrailer. Lower engine onto a suitable
engine stand or supports.
(8)
Remove chains and lifting device from engine.
(9)
Remove two nuts (2), lockwashers (3), screws (4), four washers (5) and remove two spacers (6),
pump bracket (10) and resilient mounts (7) from semitrailer.
(10)
Remove pump drive plate and pilot bearing from engine (para. 5-19).
b.
Installation.
(1) Place pump bracket (10) in position with two resilient mounts (7). Secure bracket with two
spacers (6), four washers (5), two screws (4), lockwashers (3) and nuts (2).
(2)
Place eight resilient mounts (7) and plates (8 and 9) in position on semitrailer.
(3)
Attach chains to lifting bracket at front of engine and to rear engine mounting bracket.
(4)
Attach chains to crane or lifting device. Carefully lift engine up on rear platform of semitrailer. Lower engine
assembly (1) into position on plates (8 and 9).
(5)
Install four spacers (6), eight washers (5) and four screws (4) from beneath frame
through plates (8 and 9) and engine mounting brackets.
(6)
Secure engine assembly in position with four lockwashers (3) and nuts (2).
(7)
Attach water pump brace to engine flywheel housing (para. 4-60).
5-14