CYLINDER HEAD (cont) - TM-5-3825-229-14P

CYLINDER HEAD (cont) - TM-5-3825-229-14P_260

CYLINDER HEAD (cont) - TM-5-3825-229-14P_262

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
243

TM 5-3825-229-14&P 5-7. CYLINDER HEAD (cont) a. Removal (cont). (11) Remove cylinder head assembly (20) by lifting straight up. Remove pipe plug (22). (12) Set cylinder head (20) flat on wooden supports to protect machined surfaces. (13) Remove cylinder head gasket (21). NOTE Thoroughly clean all mating surfaces of head and block. b. Installation. (1) Install new cylinder head gasket (21) on cylinder block assembly being sure that gasket mates properly with two cylinder head alignment pins. (2) Install cylinder head (20) on cylinder block assembly being sure that cylinder head mates properly with two cylinder head alignment pins. Install pipe plug (22). (3) Install eighteen screws (15) with fourteen flat washers (16) and two push rod guides (17) and torque first to 50 Ib-ft (65 Nm) (wet) per the torque sequence illustration shown below. Tighten screws in the same sequence to a final torque of 95 Ib-ft (129 Nm) (wet). 5-19

Privacy Statement
Press Release
Contact