TM 5-3825-229-14&P5-8. CRANKSHAFT PULLEY (cont)a.Removal(cont).(4)Turn pulley retaining capscrew (2) out approximately 1/2" (13 mm).(5)Thread two capscrews (4) through puller (5) into tapped holes in pulley.(6)Tighten puller screw (6) to remove pulley.NOTETo assist in loosening pulley from crankshaft, strike puller screw with a soft-faced hammer.(7)With pulley loose on crankshaft, remove puller tools.(8)Remove crankshaft pulley retaining capscrew (2), washer and pulley (3).BInspection.Inspect pulley for any burrs, nicks, or gouges in crankshaft mating area; remove if present.CInstallation.(1)Install pulley (3) and crankshaft pulley retaining capscrew (2) with washer, being sure that groove inpulley aligns with Woodruff key in crankshaft.(2)Torque crankshaft pulley retaining capscrew (2) to 98 Ib-ft (133 Nm) (wet).(3)Install plastic plugs (1) in pulley.5-23
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
