TM 5-3825-229-14&P
5-10. FLYWHEEL HOUSING (cont)
a.
Removal (cont).
(3)
Remove four capscrews (3) with flat washers (4) from inside of flywheel housing.
(4)
Tap flywheel housing (5) with a soft-faced hammer to loosen.
(5)
Lift and move flywheel housing straight back until it clears the alignment dowels.
Remove housing from engine.
(6)
Remove flywheel housing seal (6). Remove plug (21) and aligning pin (22).
(7)
Remove two nuts (7), lockwashers (8), flat washers (9) and resilient mounts (10). Remove
two screws ( 11), rear brackets (I2), spacers (13) and resilient mounts (14) from both sides
of the flywheel housing (5).
(8)
Remove four screws (15) and flat washers (16) and remove right and left rear brackets
(17) from flywheel housing.
(9)
Remove six screws (18) and lock washers (19) and remove rear engine bracket (20) from flywheel
housing (5).
b.
Inspection.
Inspect flywheel housing for cracks or other damage.
c.
Installation.
5-28
