TM 5-3825-229-14&P
5-11. OIL PAN (cont)
c
Installation.
(1)
Install new gasket (6) on oil pan (5).
(2)
Install oil pan (5) on cylinder block, holding in position with a screw (3) and Belleville washer
(4) in each corner.
(3) Install remaining twenty-six screws (3) and washers (4), but do not tighten until
all screws
are started, so that oil pan can be shifted if necessary.
CAUTION
To avoid distorting oil pan and causing leaks, do not over-torque screws.
(4)
Tighten all screws to a torque of 8 Ib-ft (1 1 Nm) (wet), starting at center and working out to
each end.
(5)
Install oil plug (1) with washer (2) in oil pan (5) and tighten securely.
(6)
Fill oil pan to proper level with specified engine oil. Refer to para. 3-2.
(7)
Install engine door. Refer to para. 4-56.
5-31
