FLYWHEEL HOUSING (cont) - TM-5-3825-229-14P

FLYWHEEL HOUSING (cont) - TM-5-3825-229-14P_270

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
253

TM 5-3825-229-14&P 5-10. FLYWHEEL HOUSING (cont) c. Installation (cont). (1) Install rear engine bracket (20) on flywheel housing (5) and secure with six lockwashers (19) and screws (18). Install plug (21) and aligning pin (22) in housing (5). (2) Install new flywheel housing seal (6) in flywheel housing (5). (3) Attach chains and lifting device to flywheel housing (5). Install flywheel housing (5), being sure that the alignment dowels in engine crankcase properly mate with alignment holes in flywheel housing. Remove lifting device. (4) Install four capscrews (3) with flat washers (4) and torque to 62 Ib-ft (84 Nm) (wet). (5) Install two capscrews (1) with flat washers (2) and torque to 62 Ib-ft (84 Nm) (wet). (6) Install flywheel (para. 5-9) and starter motor (para. 4-59). (7) Install left rear bracket (17) and right rear bracket (17) on each side of flywheel housing (5). Secure brackets with four flat washers (16) and screws (15). (8) Install two resilient mounts (14) and spacers (13) on rear engine brackets (17). Install screws (11) through rear brackets (12). Install resilient mount (10) and secure brackets and mounts with flat washers (9), lock washer (8) and nuts (7). (9) Install engine (para. 5-6). 5-11. OIL PAN THIS TASK COVERS: a. Removal c. Installation b. Cleaning and Inspection INITIAL SETUP: Tools Required: Equipment/Materials Required: Nomenclature: Rags (Item 6, Appendix E) Cleaning Solvent (Item 13, Appendix E) General Mechanics Goggles (Item 9, Appendix E) Tool Kit Equipment Conditions: Ref. Conditions 2-14 Engine shut off 3-2 Engine oil drained 4-56 Engine door removed 5-29

Privacy Statement
Press Release
Contact