OIL PUMP AND OIL PRESSURE REGULATING VALVE (cont)

OIL PUMP AND OIL PRESSURE REGULATING VALVE (cont) - TM-5-3825-229-14P_275

OIL PUMP AND OIL PRESSURE REGULATING VALVE (cont) - TM-5-3825-229-14P_277

TM-5-3825-229-14P Distributor Water Self-Propelled 2500 Gallon Capacity Sectionalized and Non-Sectionalized Models 613BWDNS Manual
Page Navigation
258

TM 5-3825-229-14&P 5-12. OIL PUMP AND OIL PRESSURE REGULATING VALVE (cont) b. Cleaning, Inspection and Repair (cont). (7) If oil pump parts inspected above are worn, scored or damaged or do not meet specifications,replace unserviceable parts. (8) Inspect screen on pump pickup tube (5) for damage. Clean screen. c. Installation. (1) Install shaft and gear (13) through plate (14) and install shaft through gearcase backplate. (2) Install a 0.5096 inch (15 mm) packing over pump shaft to use as spacer. Place pump drive gear (12) in position on shaft and secure with washer (11) and screw (10). (3) Install gear (9) in pump body (8). Lubricate gears with lubricating oil (OE/HDO). Install body, with gears (9 and 13) meshed on gearcase backplate. Secure body to engine with screw and washer (7). Do not torque screws at this time. (4) Install a new gasket (6) on oil pump (8) and install oil pump pickup tube (5). Secure tube to crankcase with washer (2) and screw (1). Tighten screw to a torque of 17 Ib-ft (23 Nm) (wet). (5) Secure pickup tube to oil pump (8) with three washers (4) and screws (3). Tighten screws (1, 3 and 7) to a torque of 17 Ib-ft (23 Nm) (wet). (6) Install screw (10), washer (11) and gear (12) on gear shaft (16). Remove packing from shaft. Rotate shaft of gear (13) to be sure oil pump gears rotate freely. (7) Install drive gear (12) on shaft and secure with washer (1 1) and screw (10). Tighten screw to a torque of 17 Ib-ft (23 Nm) (wet). (8) Refer to para. 5-11 and install oil pan. (9) Refer to para. 5-6 and install engine. 5-34

Privacy Statement
Press Release
Contact