TM 5-3895-370-14&P
G-11. ALIGNMENT STUD FABRICATION.
NOTES:
1.
FABRICATE FROM 7/16 IN. (11.18 MM) COLD ROLLED STEEL
2.
CUT FOUR RODS 8 IN. (203.20 MM) IN LENGTH.
3.
THREAD ONE END 7/16 IN. (11.18 MM) BY 20 BY 1 IN. (25.40 MM).
4.
GRIND TWO 1/4 IN. (6.35 MM) BY 1/2 IN. (12.70 MM) SPOTS ON ONE END.
5.
FILE OFF ROUGH EDGES.
Figure G-8. Alignment Stud
G-9