TM 5-3895-370-14&PG-7. EDGING/TRIM FABRICATION.Battery box edging and gage panel trim is fabricated from bulk material, 750-1/16-8-2. The battery box edging isfabricated by cutting a 4-1/2 in. (114 mm) length from bulk material with a suitable cutting device. The gage panel trim isfabricated by cutting a 5 in. (127 mm) length from the bulk material with a suitable cutting device.G-8. SAFETY CHAIN FABRICATION.Safety chain is made from bulk chain, 54T23016. The safety chain is fabricated by cutting a 21 in. (53 cm) length frombulk material with a fine toothed hacksaw or suitable cutting device. Install a detachable chain link, 54T29661, to one endof chain and release hook, 225-1 to the other end.G-9. HAIR PIN LEVER CONNECTOR BAR FABRICATION.NOTES:1.FABRICATE BAR FROM 3/8 IN. (9.65 MM) THICK MILD STEEL STOCK.2.CUT A BAR 1 IN. (25.40 MM) BY 6 9/16 IN. (166.62 MM).3.DRILL FOUR 11/32 IN. (8.64 MM) HOLES WHERE SHOWN.4.FILE OFF ROUGH EDGES.5.PAINT AS REQUIRED.Figure G-6. Hair Pin Lever Connector BarG-7
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
