TM 5-3895-370-14&P
G-10. SIDE JOINT EXTENSION CONNECTOR BAR FABRICATION.
NOTES:
1.
FABRICATE BAR FROM 3/8 IN. (9.65 MM) THICK MILD STEEL STOCK
2.
CUT A BAR 5 IN. (127 MM) BY 8 IN. (203.20 MM).
3.
DRILL FOUR 21/32 IN. (16.76 MM) HOLES WHERE SHOWN.
4.
FILE OFF ROUGH EDGES.
5.
PAINT AS REQUIRED.
Figure G-7. Side Joint Extension Connector Bar
G-8
