TM 5-3895-370-14&P
4-91. 12-VOLT SOCKET/CABLE REPLACEMENT (CONT).
(4)
Loosen two screws (10) and open cover (11) on
junction box (12).
NOTE
Tag and mark all wires before
removal.
(5)
Remove six nuts (13), lockwashers (14), and
wires (15) from six terminals (16).
(6)
Remove nut (17), lockwasher (18), washer (19),
and wire (20) from screw (21). Discard
lockwasher.
(7)
Remove wire (20) through rubber grommet (22).
(8)
Remove cable (5) from junction box (12).
b. Installation.
(1)
Install cable (5) in junction box (12).
(2)
Install wire (20) through rubber grommet (22).
(3)
Install wire (20), washer (19), lockwasher (18),
and nut (17) on screw (21).
(4)
Install six wires (15), lockwashers (14), and nuts
(13) on six terminals (16).
(5)
Close cover (11) on junction box (12) and tighten
two screws (10).
(6)
Install three clips (9) on cable (5).
(7)
Install cable (5) and three clips (9) on main
frame (6) with three lockwashers (8) and nuts
(7).
(8)
Install cable socket (5) on main frame (6) with
two washers (4), screws (3), lockwashers (2),
and nuts (1).
NOTE
Follow-on maintenance:
·
Connect negative battery cable
(para 4-84).
·
Install couplings (para 2-16).
END OF TASK
4-246
