TM 5-3895-370-14&Pa. Removal.WARNINGHydraulic fluid is very slippery and can cause falls. To avoid injury, wipe upspilled fluid with rags.CAUTIONEquipment damage may occur if hydraulic lines and fittings are not plugged andcapped after removal.NOTETag and mark all hydraulic lines before removal.(1)Disconnect two hoses (1 and 2) from crossoverrelief valve (3).(2)Remove two locknuts (4), washers (5), screws(6), and cross-over relief valve (3) from bracket(7). Discard locknuts.(3)If damaged, remove two screws (8), lockwashers(9), and bracket (7) from flywheel housing cover(10). Discard lockwashers.b. Installation.(1)If removed, install bracket (7) on flywheelhousing cover (10) with two lockwashers (9) andscrews (8). Tighten screws 45 lb-ft (61 Nm).(2)Install cross-over relief valve (3) on bracket (7)with two screws (6), washers (5), and locknuts(4).NOTERefer to tags to properly installhydraulic lines.(3)Connect two hoses (1 and 2) on cross-over reliefvalve (3).END OF TASK4-243
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
