CHASSIS WIRE HARNESS REPLACEMENT (cont)

CHASSIS WIRE HARNESS REPLACEMENT (cont) - TM-5-3895-370-14P_390

HYDRAULIC CROSS-OVER RELIEF VALVE REPLACEMENT

TM-5-3895-370-14P Spreader Aggregate: Towed; 3 Ft Spread FF-8 (NSN 3895-01-329-5096) Manual
Page Navigation
379

TM 5-3895-370-14&P (6) Install chassis wire harness (1) on rear markerlight (14) as follows: (a) Connect wire connector (15) on wire harness (1) and left rear markerlight (14). (b) Install spiral cable wrap (3) on wire harness (1). (c) Repeat Steps (a) and (b) for right rear markerlight (14). (7) If removed, install nine clamps (9 and 12) on wire harness (1). (8) Install wire harness (1) on spraybar center section (13) with six clamps (12), lockwashers (11), and nuts (10). (9) Install chassis wire harness (1) on identification/clearance light assembly (2) as follows: (a) Install wire harness (1) on identification/clearance light assembly (2) with three clamps (9), lockwashers (8), and nuts (7). (b) Connect three wire connectors (4) on bar light assembly (6), two clearance lights (5), and wire harness (1). (c) Install spiral cable wrap (3) on wire harness (1). NOTE Follow-on maintenance: · Install chassis wire harnesses on amp breaker box (para 4-88). · Connect negative battery cable (para 4-84). END OF TASK 4-241

Privacy Statement
Press Release
Contact