TM 5-3895-370-14&P
(3)
Remove rotor (4) and washer (5) from drive end
shield (1).
(4)
Remove bearing (6) from rotor (4).
(5)
Remove retaining ring (7) and bearing (8) from
drive end shield (1).
(6)
Remove two screws (9) and regulator (10) from
housing (2).
(7)
Remove two screws (11), lockwashers (12), and
brush assembly (13). Discard lockwashers.
(8)
Remove nut (14), lockwasher (15), nut (16),
washer (17), and two insulated washers (18 and
19) from housing (2). Discard lockwasher.
(9)
Remove stator (20) from housing (2).
(10)
Remove three screws (21), terminal board (22),
and wire clamp (23) from housing (2).
(11)
Remove two screws (24) and terminal board
(25) from housing (2).
(12)
Remove assembled screw (26) and capacitor
(27) from housing (2).
(13)
Remove three screws (28 and 29), rectifier
bridge (30), and bridge insulator (31) from
housing (2).
5-87
