TM 5-3895-370-14&P(2)Inspect gear teeth for pitting, cracks, and excessive wear.(3)Inspect cover, housing, and flange for excessive wear.(4)Inspect bearing assemblies for roughness and excessive wear.d.Assembly.(1)If removed, install four dowel rings (13) in housing (5).NOTELubricate all preformed packings and retaining rings with hydraulic fluid prior toassembly.(2)Install drive gear (12), idler gear (11), and two bearing assemblies (10) in housing (5).(3)Install four preformed packings (9) on cover (3)and flange (4).(4)Install two preformed packings (8) on housing(5).WARNINGAdhesive causes immediatebonding on contact with eyes, skin,or clothing and also gives offharmful vapors. Wear protectivegoggles and use in well-ventilatedarea. If adhesive gets in eyes, try tokeep eyes open; flush eyes withwater for 15 minutes and getimmediate medical attention.NOTEApply adhesive sealant on shaft sealbefore installation.(5)Install shaft seal (7) and retaining ring (6) inflange (4).(6)Install flange (4) and cover (3) on housing (4)with four lockwashers (2) and screws (1).5-125
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
