TM 5-3895-370-14&P5-67. PISTON AND CONNECTING ROD REPLACEMENT/REPAIR (CONT).d. Assembly.CAUTION·Install rings with printed side up.Improper installation will causedamage to engine.·End gaps of rings must be 120°apart from each other. Improperinstallation will cause damage toengine.(1)Lubricate rings (8, 9, and 10) with engine oil.NOTEEnd gap of rings must be at oppositeends of each other.(2)Install oil ring expander (11) and oil control ring(10).(3)Install intermediate ring (9) and top ring (8).(4)Install one retaining ring (5) in piston (7).CAUTIONMarkings on piston head andnumbers on connecting rod must beoriented in same direction for properassembly. Failure to do so will resultin damage to engine.(5)Assemble piston (7) and connecting rod (3) securing with wrist pin (6).(6)Install remaining retaining ring (5).CAUTIONDo not apply grease on outer diameter of bearing halves or damage may result tobearing halves, related bearing caps, and crankshaft.(7)Lubricate eight bearing halves (1 and 2) with general purpose grease.(8)Install eight bearings halves (1 and 2) in four connecting rods (3) with four rod caps (4).5-284
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
