Connect Throttle Cable to Control Head

TM-55-1930-209-14P-17 Water Purification Barges (NSN 1930-01-234-2165) Miscellaneous Equipment Dayroom Workshop Access and Sanitation Systems Manual
Page Navigation
760

CAUTION The clutch lever has two sets of terminal holes on each end (See Clutch Lever Drawing). Use the inner hole for 1-1/8" travel (required for electric switch). Use the outer hole for 2-3/4” travel (standard required by most transmissions). 6. Securely fasten clutch cable to housing (13) using cable clamp (25) and screws (31). CAUTION Be sure key on the underside of cable clamp is seated in the groove of cable hub. 3. Connect Throttle Cable to Control Head IMPORTANT Be sure the control head is correctly assembled for PUSH-TO-OPEN or PULL-TO- OPEN throttle operation as required (see Figure 4). If necessary. modify as follows: (a) Remove screws (30) and lockwashers (9) from retainer plate (27). Also remove screw (18), shoulder bushing (29), collar (24) and stopnut (23) from swivel bracket (28). (b) Rotate retainer plate 180 so V-point is Down for Pull or Up for Push. Then replace screws (30) and lockwashers (9). Insert screw, shoulder bushing and swivel bracket into retainer plate link (27) hole and housing slot. Replace collar and stopnut. (c) Move hand lever from neutral and loosen setscrew (19). Return hand lever to neutral and remove from control. (d) Press spring-loaded throttle lever toward outside of housing until pin (15) is clear of keyway. Rotate throttle lever 180 until pin snaps back into keyway. Replace control hand lever and tighten setscrew. 1. Screw throttle terminal (4) onto cable rod until 1/8" of the rod shows through terminal. Hold terminal securely to prevent it from turning and tighten cable nut against terminal. 2. Apply lubricant and place terminal (4), flatwasher (24), and retaining ring (3) on throttle arm (5). 3. Securely fasten throttle cable to swivel bracket (28), using cable clamp (25) and screws (31). Be sure key on underside of cable clamp is seated in groove of cable hub. 4. Control should appear as shown in Figure 4 for proper throttle operation. 5. Reassemble control head. 4. Install Control Cables 1. Run the two cables into the cutout, down through the column and to the engine.

Privacy Statement
Press Release
Contact