STEP 5/CYLINDER CONNECTION Place the nylon washer on the support rod. For    Mercury/Mariner    inline    engines    80 through 140 HP) place the one inch spacer bushing  on  the  rod  before  putting  on  the washer. VERY  IMPORTANT.    Grease  the  support rod thoroughly with a good waterproof and anti-corrosive  grease  such  as  OMC  triple guard equivalent. Insert the support rod into the tilt tube from starboard side. Place a nylon washer on the protruding end of the support rod then bolt on the support rod collar and tighten loosely. Remove   free   play   in   the   support   rod   by   prying   the   end   with  a screwdriver while tightening the nut and bolt firmly.  A helper is needed for  this  step.    For  dual  engine  installations  refer  at  this  point  to instructions included with tie-bar kit. CONNECT THIS CYLINDER KIT ONLY TO OUTBOARD MOTORS LISTED ON THE FOLLOWING ENGINE APPLICATION GUIDE OUTBOARDS ENGINE MFG. MODEL YEAR HORSE POWER CYLINDER PIN TIE BAR KIT Chrysler 1983 - To Date 85 and up HC 5301 HO 5013 Johnson-Evinrude 1977 - To Date 70 and up HC 5301 HO 5013 Mercury 1978 - 1979 150 and up HC 5302 N/A Mercury/Mariner 1980 - 1981 V-6 Eng. only - HC 5301 HO 5011 Mercury/Mariner 1982 - 1984 V-6 Eng.  only HC 5301 HO 5012 Mercury/Mariner 1980 - 1983 In-Line Eng.  Only HC 5301 HO 5013 Mercury/Mariner 1984 - To Date 90 - 115 HC 5303 HO 5014 Mercury/Mariner 1985 - To Date V-6 Eng.(exc.  3.4) HC 5303 HO 5014 Yamaha 1983 - To Date 1 t 5 and up HC 5301 HO 5012 OMC Seadrive Refer to order guide