TM 9-2330-267-14&P
4-52. SHOCK ABSORBER REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Materials/Parts:
Tools/Test Equipment:
c Two Iockwashers
l General mechanic’s tool kit
NOTE
There are two shock absorbers on the water tank trailers. Replacement of one shock
absorber is covered in this task.
a . R E M O V A L
1.
Remove two nuts (6), Iockwashers (5), recessed washers (4), and shock absorber (3) from frame stud (1) and
axle stud (7). Discard Iockwashers.
2.
Remove four rubber bushings (2) from shock absorber (3). Replace rubber bushings if damaged.
b .
INSTALLATION
1.
Install four rubber bushings (2) in shock absorber (3). Position shock absorber on frame stud (1) and axle stud
(7) .
2.
Install two recessed washers (4), new Iockwashers (5), and nuts (6) on frame stud (1). Ensure that nuts are fully
tightened.
TA507059
4-98
