TM 9-2330-267-14&P
4-53. RADIUS ROD MAINTENANCE (Con’t).
d.
INSTALLATION
1,
Aline radius rod (4) and two flatwashers (19) in bracket (20) and install sleeve bearing (21).
2.
Install two bushings (18) and shouldered washers (17) in bracket (20).
3.
Install cap screw (22), nut (16), and new locknut (15) in bracket (20).
4.
Tighten screw (14) on radius rod (4).
5.
Install bumper (13), flatwasher (12), new Iockwasher (11), and screw (10) in bracket (20).
6.
Install two bushings (9) and flatwashers (8) in bracket (5).
7.
Install radius rod (4) and sleeve bearing (3) in bracket (5).
8.
Install two shouldered washers (2), capscrew (1), nut (6), and new locknut (7).
e.
ADJUSTMENT]
NOTE
Ensure that distance between connectors is the same as that recorded when radius rod
was removed.
1.
Measure distance between connectors (23). If
measurement is the same as measurement
recorded during removal of radius rod, adjustment
is correct. If adjustment is not correct, go to step 2.
2.
Loosen screws (24) and turn rod (25) clockwise to
shorten and counterclockwise to lengthen dis-
tance between connectors (23).
3.
When measurement between connectors (23) is
same as that recorded during removal of radius
rod, tighten screws (24).
FOLLOW-ON TASKS:
l Install spring assembly (para 4-51).
TA507062
4-101
