TM 9-2330-267-14&P
4-26. CHASSIS WIRING HARNESS REPAIR.
This Task Covers:
a.
Identification Band Replacement
c.
Male Connector Repair
b.
Terminal Replacement
d. Female Connector Repair
Initial Setup:
Equipment Conditions:
Materials/Parts:
Q Intervehicular cable disconnected from towing
l Marker tags (as required) (Item 25, Appendix E)
vehicle (para 2-12).
s Contacts (as required)
Tools/Test Equipment:
. Identification bands (as required)
l General mechanics tool kit
l Terminals (as required)
. Electric etcher
a.
IDENTIFICATION BAND REPLACEMENT
1.
Remove identification band (2) from wire lead (1)
and discard.
2.
Mark new identification band (2) with proper
identification number.
3.
Position new identification band (2) on wire lead
(1) and bend tabs over wire lead.
b .
TERMINAL REPLACEMENT
1.
Cut terminal (3) off wire lead (4) and discard.
2.
Strip insulation off wire lead (4) equal to depth of
new terminal (3).
3.
Position new terminal (3) on wire lead (4) and
crimp terminal.
c .
MALE CONNECTOR REPAIR
1.
Slide shell (7) back and remove washer (8) from wire lead (6). Cut contact (5) from wire lead and discard.
Remove shell.
2.
Strip insulation off wire lead (6) equal to depth of new contact (5).
TA507013
4-40