TM 9-2330-267-14&P
4-25. CHASSIS WIRING HARNESS REPLACEMENT (Con’t).
c.
INSTALLATION
1.
Position rear clip assembly (4) on frame assembly and install four flatwashers (8), nuts (10), and screws (7).
2.
Position clip assembly (3) on frame assembly and install four new Iockwashers (18) and screws (19).
3.
Position chassis wiring harness (14) on frame assembly and install grommet (9).
NOTE
The quantity of tie-down straps, clips, and mounting hardware will vary among the
M149, M149A1, and M149A2 trailers. Steps 4 and 5 are typical for the M149.
4.
Install three screws (17), new Iockwashers (16), tie-down straps (15), and nuts (20) on chassis wiring harness
(14) and frame assembly.
5.
Install three screws (21), tie-down straps (22), flatwashers (11), new lockwashers (12), and nuts (13) on chassis
wiring harness (14) and frame assembly.
6.
Connect six front plug connectors (1) to intervehicular cable (2). Connect rear plug connectors (5) to right and left
light assemblies (6).
TA507011
4-38
