TM 10-3835-223-13&P
Table 3-1. Operator Troubleshooting - cont.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
10. REEL WILL NOT TURN (PUMP OPERATES).
Step 1. Check position of REEL CW/CCW switch.
Set switch to CCW or CW, as required.
Step 2. Check position of REEL LEFT/NEUTRAL/RIGHT switch.
Set switch to LEFT or RIGHT, as required. Do not select NEUTRAL.
Step 3. Check that brake is released.
Raise brake lever to up position.
Step 4. Check for tangled or jammed hose.
Untangle hose from frame.
Step 5. Check for loose or disconnected hose couplings.
Connect loose or disconnected hose couplings (para. 2-6a).
Step 6. Check fluid level in reservoir.
If fluid in reservoir is low, notify unit maintenance.
NOTE
If malfunction cannot be corrected, notify unit maintenance.
11. REEL TURNS ONE DIRECTION ONLY.
Step 1. Check for tangled or jammed hose.
Untangle hose from frame.
Step 2. Check for loose or disconnected hydraulic hose couplings.
Connect loose-or disconnected hose couplings (para. 2-6a).
NOTE
If malfunction cannot be corrected, notify unit maintenance.
12. DRIVE WHEEL SLIPS ON HOSE REEL HUB.
Step 1. Check position of REEL LEFT/NEUTRAL/RIGHT switch.
Set switch to LEFT or RIGHT, as required. Do not select NEUTRAL.
3-6
