TM 10-3835-223-13&P
Table 3-1. Operator Troubleshooting - cont.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. DRIVE WHEEL(CYLINDER) MOVES TO LEFT REEL WHEN RIGHT REEL IS SELECTED.
NOTE
References to left, right, clockwise, and counterclockwise are based on operator
standing on the brake lever side of frame while facing the unit.
Step 1. Check position of REEL switch.
On control cable, set REEL switch to LEFT or RIGHT, as required.
Step 2. Check for reversed hose connections at quick disconnect couplings.
a.
Connect frame unit hoses with white sleeves to power pack hoses with white sleeves (para.
2-6a).
b.
Connect frame unit hoses without sleeves to power pack hoses without sleeves (para. 2-6a).
NOTE
If malfunction cannot be corrected, notify unit maintenance.
3. DRIVE WHEEL (CYLINDER) MOVES TO RIGHT WHEN LEFT REEL IS SELECTED.
See MALFUNCTION 2.
4. DRIVE WHEEL (CYLINDER) DOES NOT MOVE WHEN RIGHT OR LEFT REEL IS SELECTED.
Step 1. Check position of control cable REEL switch.
NOTE
Cylinder will not move when REEL switch is set to NEUTRAL.
Set REEL switch to LEFT or RIGHT, as required.
Step 2. Check for loose or disconnected hydraulic hose couplings.
Connect loose or disconnected hydraulic hose couplings (para. 2-6a).
NOTE
If malfunction cannot be corrected, notify unit maintenance.
3-3
