TM 10-3835-223-13&P3-4. TROUBLESHOOTING TABLERefer to Table 3-1.Table 3-1. Operator TroubleshootingWARNINGBe sure to read ALL Warnings in front of manual before troubleshootingMALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTION1. REEL WILL NOT OPERATE WHEN RUN SWITCH IS DEPRESSED.Step 1. Check control cable switch settings.Set switches as required for hose deployment or retrieval.Step 2. Check control cable connection to power pack.Tighten connection.Step 3. Check slave cable connection at vehicle power source.Push connector into power receptacle.Step 4. Check slave cable connection at power pack.Push connector into power pack receptacle.Step 5. Reset power pack circuit breaker.a. Remove power pack from frame unit (para. 2-8a).b. Remove guard from power-pack (para. 3-6).c. Using flat tip screwdriver, open lid on metal enclosure and reset circuit breaker.d. Secure lid on metal enclosure.e. Install guard on power pack (para. 3-6).f. Install power pack in frame unit (para. 2-6a).NOTEIf malfunction cannot be corrected, notify unit maintenance.3-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business