TM 10-3835-223-13&P
Table 3-1. Operator Troubleshooting - cont.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
5. DRIVE WHEEL (CYLINDER) MOVED IN ONE DIRECTION, BUT WILL NOT RETURN.
Step 1. Check position of control cable REEL switch.
NOTE
Cylinder will not move when REEL switch is set to NEUTRAL.
Set REEL switch to LEFT or RIGHT, as required.
Step 2. Check for loose or disconnected hydraulic hose couplings
Connect loose or disconnected hydraulic hose couplings (para. 2-6a).
NOTE
If malfunction cannot be corrected, notify unit maintenance.
6. DRIVE WHEEL (CYLINDER) MOVES VERY SLOWLY.
Step 1. Check for 24Vdc electrical power from slave vehicle.
Connect slave cable to vehicle with adequate electrical power.
Step 2. Check fluid level in hydraulic reservoir.
If fluid in reservoir is low, notify unit maintenance.
NOTE
If malfunction cannot be corrected, notify unit maintenance.
7. REEL TURNS CLOCKWISE WHEN CCW IS SELECTED.
NOTE
References to left, right, clockwise, and counterclockwise are based on operator
standing on the brake lever side of frame while facing the unit.
Step 1. Check position of REEL CW/CCW switch.
Set switch to CCW or CW, as required.
Step 2. Check for reversed hose connections at quick disconnect couplings.
Refer to MALFUNCTION 2, Step 2.
NOTE
If malfunction cannot be corrected, notify unit maintenance.
3-4
