TM 10-3835-223-13&P
Table 3-1. Operator Troubleshooting - cont.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
12. DRIVE WHEEL SLIPS ON HOSE REEL HUB -cont.
Step 2. Check drive wheel and hose reel hub for dirt, fuel, and oil on drive surfaces.
a.
Using clean cloth, wipe contaminants from drive wheel
b.
Using clean cloth, wipe contaminants from drive surface of hose reel hub
NOTE
If malfunction cannot be corrected, notify unit maintenance.
Section III. OPERATOR MAINTENANCE PROCEDURES
Page
General
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-8
Power Pack Guard Removal/Installation
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-8
3-5. GENERAL
This section contains procedures for performing operator maintenance on the hose reel system.
3-6. POWER PACK GUARD REMOVAL/INSTALLATION
This task consists of:
a. Removal
b. Installation
INITIAL SET-UP:
Tools required:
Phillips Screwdriver (Appendix C, Section III, Item 2)
Equipment Condition:
Power Pack Removed (paragraph 2-8a).
a. Removal.
(1)
Remove eight screws (1) and eight flat washers (2).
(2)
Lift power pack guard (4) from frame (3).
3-7
