TM 10-4130-237-14
4-28.
4-78
FLYWHEEL AND RING GEAR ASSEMBLY REPLACEMENT/REPAIR (CONT)
8 Inspect flywheel for worn keyway. Inspect ring gear for worn or missing teeth.
9 If removing ring gear from flywheel, place assembly on flat surface with ring gear side up.
10 Using centerpunch, mark the center of the four rivets holding the ring gear to the flywheel.
12 Drill out rivets. Clean holes after drilling.
13 Beat flywheel to soften epoxy holding ring gear.
14 Remove ring gear and clean epoxy from flywheel and ring gear.
