TM 10-4320-303-13
Figure 2-57. End Cap Installation.
p. Locate end cap (Figure 2-57, 1). Connect end cap (1) to end of hoseline segment (2) using grooved-
end pipe quick disconnect coupling clamp (3) (para 2.3.3.2).
q. Disconnect air compressor line (Figure 2-56, 9) with pneumatic coupler (8) from pneumatic coupler
(5) on end cap (6).
Figure 2-58. Collapsing Hoseline.
r. Locate ejector assembly (Figure 2-58, 1) and two pneumatic couplers (2). Install pneumatic couplers
(2) on threaded fittings on ejector assembly (1).
s. Install ejector assembly (1) on end cap (3) with pneumatic coupler (4).
t. Connect air compressor line (5) with pneumatic coupler (6) to ejector assembly (1).
u. Apply air pressure to ejector assembly (1). Operate compressor for 10 minutes to collapse hoseline
(7) for repacking.
v. Turn off air compressor and disconnect air compressor line (5) with pneumatic coupler (6).
w. Disconnect ejector assembly (1) and set aside.
2-93
