PREPARATION FOR MOVEMENT - cont - TM-10-4320-303-13

PREPARATION FOR MOVEMENT - cont - TM-10-4320-303-13_124

PREPARATION FOR MOVEMENT - cont - TM-10-4320-303-13_126

TM-10-4320-303-13 Tactical Water Distribution Equipment System (TDWS) Set 10-Mile Segement Model 06749-0813-81 110-00-0000 919 and 10 Manual
Page Navigation
113

TM 10-4320-303-13 2.8.2 Preparation for Movement of 10-Mile Hoseline. (Continued) f. Install four square-neck bolts (3), flat washers (4), and self-locking nuts (5) in holes. g. Tighten each nut (5) until heads on bolts (3) are flush with surface of pullboard half (2). h. Repeat steps e through g to install right pullboard flange (6) on second pullboard half (7). i. Place pullboard halves (2 and 7) in coupling sleeve (8). Align holes in pullboard halves (2 and 7) with holes in coupling sleeve (8). j. Install six cap screws (9), flat washers (10), and self-locking nuts (11) in holes. k. Tighten each self locking nut (11) until pullboard halves (2 and 7) are firmly secured in coupling sleeve (8). l. Install nut (12) and flat washer (13) on eyebolt (14). NOTE When installing eyebolt through coupling sleeve, make sure eyebolt and flanges are on opposite sides of pullboard. m. Place eyebolt (14) through hole in top of coupling sleeve (8). Install flat washer (15) and nut (16). Figure 2-61. Start Hoseline Packing. n. Install nut (Figure 2-61, 1) on eyebolt (2). Turn nut (1) to its limit of travel. 2-96

Privacy Statement
Press Release
Contact