INSTALLATION INSTRUCTIONS

Table 4-4. 10-Mile Segment Crate. (Continued) - TM-10-4320-303-13_165

Table 4-6. Unit Maintenance Preventive Maintenance Checks and Services - TM-10-4320-303-13_167

TM-10-4320-303-13 Tactical Water Distribution Equipment System (TDWS) Set 10-Mile Segement Model 06749-0813-81 110-00-0000 919 and 10 Manual
Page Navigation
154

TM 10-4320-303-13 equipment prior to packaging. It also explains what has to be done before placing the equipment in operation. Perform all depreservation actions required by the depreservation guide. 4.5 INSTALLATION INSTRUCTIONS . Refer to paragraph 2.3 of this manual for TWDS installation instructions. 4.6 PRELIMINARY SERVICING AND ADJUSTMENT OF EQUIPMENT . Refer to paragraph 2.4 of this manual for preliminary servicing and adjustment of TWDS. 4.7 TWDS LUBRICATION . The TWDS does not require any general lubrication. Refer to the applicable technical manuals for 125 GPM and 600 GPM Pumping Assemblies. SECTION III. UNIT PREVENTIVE MAINTENANCE CHECKS AND SERVICES 4.8 INTRODUCTION TO UNIT PMCS TABLE . Table 4-7 has been provided so you can keep your TWDS equipment in good operating condition and ready for its primary mission. Additional PMCS procedures for TWDS equipment are contained in Table 2-7, Operator PMCS, and Chapter 2, Section II of this manual. Refer to applicable technical manuals for specific component PMCS: a. 125 GPM Pumping Assembly b. 20,000 Gallon Pillow Tank c. Hypochlorination Unit, Model A-506131 d. Hypochlorination Unit, Model 1955-3 e. 600 GPM Pumping Assemblies 4.8.1 Explanation of Table Entries. 4.8.1.1 Item No. Column . Numbers in this column are for reference. When completing DA Form 2404 (Equipment Inspection and Maintenance Worksheet), include the item number for the check/service indicating a fault. Item numbers also appear in the order that you must do checks and services for the intervals listed. 4.8.1.2 Interval Column. This column tells you when you must do the procedure in the procedure column. BEFORE procedures must be done before you operate or use the equipment for its intended mission. DURING procedures must be done during the time you are operating or using the equipment for its intended mission. AFTER procedures must be done immediately after you have operated the equipment. 4.8.1.3 Location and Item to Check/Service Column. This column provides the location and the item to be checked or serviced. The item location is underlined. 4.8.1.4 Procedure Column. This column gives the procedure you must do to check or service the item listed in the Check/Service column to know if the equipment is ready or available for its intended mission or for operation. You must do the procedure at the time stated in the interval column. 4.8.1.5 Not Fully Mission Capable if : Column. Information in this column tells you what faults will keep your equipment from being capable of performing its primary mission. If you make check and service procedures that show faults listed in this column, do not operate the equipment. Follow standard operating procedures for maintaining the equipment or reporting equipment failure. 4-9

Privacy Statement
Press Release
Contact