TM 10-4320-303-13
a. Make sure each flaking box (1) is properly aligned and nested in top angle (3) of flaking box (1) below.
WARNING
Make sure crane or forklift has minimum lifting capacity of 6,000 pounds.
DO NOT stand under load being lifted as death or serious injury may result.
NOTE
If using lifting sling (2), attach hooks to lifting clevises (4) on bottom flaking box
(5).
Ensure open ends of hooks face outward.
Ensure tailgate assemblies of flaking boxes face rear of truck.
b. Using crane or forklift with 6,000 pound lifting capacity, lift and stack flaking boxes on truck bed. DO
NOT load or stack more than four flaking boxes on one truck at a time. Position flaking boxes on
truck bed with tailgate assemblies facing to rear.
c. If truck does not have side walls, use lifting devises (4) as attachment points and securely tie boxes to
truck.
Figure 2-31. Tailgate Assembly Removal.
d. Remove two screws (Figure 2-31, 1) on rear of bottom flaking box (2) that secure tie bar (3) to flaking
box (2).
e. Lift and remove tie bar (3) from flaking box (2).
f. Lift and remove tailgate assembly (4).
g. Install tie bar (3) on flaking box (2).
2-65
