BULB REPLACEMENT

Fig. 12 Removing Bulb from face of Cluster

LIGHT ASSEMBLY REPLACEMENT - TM-5-3820-256-24-4_423

TM-5-3820-256-24-4 Drilling System Well Rotary Truck Mounted Air Transportable 600 Feet Capacity Model LP-12 NSN 3820-01-246-4276 Manual
Page Navigation
324

SERVICE MANUAL 5. Connect wiring cable to new light assembly. 6. Position light assembly on cab panel and secure with mounting screws. 7. Check light operation. TAIL, STOP, REAR TURN SIGNAL, BACK-UP LIGHTS BULB REPLACEMENT (Refer to Figure 16) 1. Remove lens mounting screws (4). 2. Pry lens from light assembly. 3. Press bulb in lightly and turn counterclockwise to disengage retaining pins. 4. Pull bulb from socket. 5. Inspect lens and gasket and replace if damaged. 6. Install new bulb as follows: a. Align retaining pins with slots in socket. Stop, tail, turn signal bulb has staggered retaining pins to assure correct positioning in socket. b. Push bulb into socket and turn clockwise to secure retaining pins. 7. Position gasket and lens in light assembly and secure with screws. 8. Check light operation. Fig. 16 Tall, Stop. Rear Turn Signal, Back-Up Light 1 Light Assembly 3Bulb (Tail, 2 Bulb (Back-up) Stop, T-Sig.) 4Terminal Cover CTS- CTS - 4088 Page 9

Privacy Statement
Press Release
Contact