SERVICE MANUAL
Fig. 18 Ashtray Light
1
Ashtray Housing
2
Light Assembly
6.
Discard old light assembly.
7.
Hold lens in hole in ashtray housing and snap
new light assembly over lens to retain lens and
light assembly.
8.
Connect light assembly wiring connector to
wiring harness connector.
9.
Position cluster panel (with ashtray housing,
radio, etc.) on instrument panel and secure with
screws.
10.
Position ashtray in ashtray housing.
11.
Check light operation.
HEATER/AIR CONDITIONING
CONTROL LIGHT
BULB REPLACEMENT
1.
Remove control assembly mounting screws.
Remove trim plate. Pull control assembly
outward. It may be necessary to remove ashtray
to
allow
movement
of
control
assembly.
2.
Rotate light socket (Figure 19) clockwise (as
viewed from rear of vehicle). Pull light socket
(with bulb) from control assembly.
Fig. 19 Heater/Air Conditioning Control Light
1. Control Assembly
2. Light Socket
3.
Grasp bulb and pull straight outward to remove
plug-in type bulb from socket.
4. Insert new bulb into socket.
5. Insert light socket into control assembly. Turn
light socket to secure in position.
6. Position control assembly in instrument panel and
install trim plate and mounting screws.
7. Check light operation.
CTS - 4088 Page 11
