STAMPED ANGLE SPRING CLUTCHTRANSMISSION AND CLUTCH REMOVAL FOR SAS-1402 TWO PLATESpicer clutches should be replaced when adjustmentcannot correct for a loss of free pedal or a slippingclutch.TRANSMISSION REMOVALA sling or a jack supporting the transmission and driveshaft during removal helps maintain alignment. Do notlet the rear of the transmission drop. or let thetransmission hang unsupported in the splined hubs ofthe clutch discs Taking these precautions will preventbending and distortion of the clutch discs.Install the spline aligning tool Into the release bearingassembly and driven discs, An old transmission Inputshaft may be used for this purpose.Disconnect the external clutch linkage before pulling thetransmission freeInsert two 5/8" spacers between the flywheel ring and therelease bearing housing Spacers relieve the heavyinternal spring load In the clutch assembly.CTS-4195 Page 8
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
