SERVICE MANUALCRANKSHAFT, MAIN BEARINGS, FLYWHEEL & CRANKCASESection 6Figure 32. - Assembling Seal to Sleeve1.Seal (single lip)2.Chamfer on O.D. of sleevee.Install the retainer (1, Fig. 36) retainergasket (2) (if equipped) on the flywheelhousing prior to installing unitized seal andsleeve assembly.f.Install the flywheel housing if it wasremoved.NOTE: Seal bore in housing or retainer must beconcentric with crankshaft within 0.25 mm (0.010 in.)full indicator measure as shaft is rotated 360°.g.Attach the centering plate (2, Fig.33) to thecrankshaft flange (1) using the four alienhead screws. DO NOT tighten the screwsat this time.NOTE: Only four bolt holes in the crankshaft willline up with the holes in the centering plate.Figure 33. - Installing Oil Seal and Wear Sleeve1.Crankshaft flange2.Centering plateh.Position the wear sleeve (3, Fig. 34) with oil seal(1) on the centering plate (2) and crankshaft asshown. Tighten the four allen head screws.Figure 34. - Oil Seal and Wear Sleeve Installation1.Oil seal2.Centering plate3.Wear sleeveNOTE:Never remove the oil seal from the sleeveduring assembly.CGES-185-3PRINTED IN UNITED STATES OF AMERICAPage 25
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
