SERVICE MANUAL
7.
On DT-466 applications, slide the compressor
wheel from the turbine shaft. If carbon buildup
prevents easy removal, press the shaft from the
compressor wheel according to Step 9.
9.
Support the center housing assembly on the
arbor press as shown in Fig. 16. Grind the
radius on the end of a 1/4 inch bolt to fit the end
of the shaft. Press the shaft from the
compressor wheel.
Hold the turbine wheel and shaft to prevent
it and the shroud from being damaged by
dropping.
Fig. 16. Separating Compressor Wheel From Turbine
Shaft
1. Bolt
2. Compressor Wheel
10.
Straighten the tabs on the lock plates and loosen
the capscrews securing the center housing to
the back plate (Fig. 17). Do not remove the
capscrews in this position.
Fig. 17. Center Housing Assembly
1. Center Housing
2. Shroud
3. Lock Plate
4. Back Plate
CTS-4104
PRINTED IN UNITED STATES OF AMERICA
Page 12
