WHEELS, RIMS AND TIRES
Figure 9. - Disc Rear Wheel Assembly
DISC WHEELS (FIGURES 2 AND 9)
Tire and Wheel Service, Inboard and Outboard
Mounted Drum
Brake Service, Outboard Mounted Drum
1.
Set parking brake or block wheels to prevent
vehicle from moving.
2.
Position vehicle on floor stand(s).
3.
If brake service is to be performed, loosen or
back off brake adjustment so that it will move
freely with- out drag.
4.
Remove wheel nuts (outer nuts with dual wheels
at rear) (Figure 10).
Figure 10. - Remove Outer Wheel Nuts
5.
Remove wheel from wheel studs.
6.
On dual wheel installations, remove the inner
wheel nuts (Figure 11).
Figure 11. - Remove Inner Wheel Nuts
7.
The brake drum can now be removed, if
outboard mounted (Figure 12). The brakes can
now be serviced after the wheel and tire
assembly has been removed.
Figure 12. - Remove Drum Assembly
8.
Installation of wheel and tire assembly is
essentially the reverse of the removal procedure.
Special attention must be given to the following:
CTS-4148A
Page 6
