B - Before D - During A - After W - Weekly M - Monthly Item Interval Item to Be Procedure Check for and have repaired or Equipment is Not Ready/Available No. B   D   A  W  M Inspected adjusted as necessary If: TM 5-3895-370-14&P 2-8.  OPERATOR PMCS TABLE (CONT). Table 2-2.  Operator Preventive Maintenance Checks and Services - CONT. NOTE: Within designated interval, these checks are to be performed in the order listed. CONTROL CONSOLE- CONTINUED 51 Gage Panel Visually inspect for damaged gages Obvious damage to gages or or switches. Switches. 52 Control Console Visually inspect for damaged Obvious damage to levers, levers, meters, or switches meters, or switches. CAUTION Do    not    operate    bituminous pump     for     longer     than     60 seconds without pumping material. 53 Pump Slowly move control lever forward Levers bind or pump lever will Transmission (FWD) to ensure free pump not engage. Control Lever operation (para 2-02). BITUMINOUS SYSTEM 54 Bituminous Operate bituminous system System (para 2-20) and check for the Operation following: a. Ensure flow meter is operating a. Flow meter does not operate. 54 Bituminous Operate bituminous system System (para 2-20) and check for the Operation- following Continued b Ensure bituminous mater b. Bituminous material not flows through system flowing at set rate or not at all.     c. Inspect for signs of leakage in c. Class III bituminous system. Material leakage is present. 2-16